Stand out from the crowd. This Hobby Wireless exclusive new 3.3 GHz system will make FPV better than ever. It has been completely designed and tailored for FPV, with great features, such as:a new switching regulator, ceramic high efficiency low profile heat sinks, high quality audio channel, it runs way cooler, with a much lower profile.
This groundbreaking system customized by Hobby Wireless for FPV applications means it's better and easier to use.  
It is is a complete plug and play wireless system.  The system's advantages are quick and easy setup, and a wide operating voltage range.

The plug and play board has lots of important features built-in such as:
- High quality microphone
- Audio volume control
- High quality 12V camera voltage regulator (no heat and noise free)
- Reverse-Polarity Protection (avoids damage if you plug the battery pack inverted)
- Operating Voltage range:10.5 to 22.0 VDC
- Molex connector with safety latch for secure connections.
- Power LED (helps to identify bad power connection, reminds you to disconnect power when it’s not in use)
-Transmitter on/off switch

What's new?
 It now can be used with a larger variety of FPV platforms. 3.3 GHz is an advantage, you don't have to worry about harmonics affecting your radio on 2.4 or 433.  
 The New TXV3300 allows use with many different models, independent of their size. 
 The transmitter can be powered through a JST connector and the receiver using a regular power plug. Any power source from 10.5 to 22 volts DC, example a 3S 11.1v lithium battery will perfectly power your system.
 To get the most performance out of this system using a high gain antenna for the receiver, and it will not only increase the range but the quality of the reception as well.
The receiver has high sensitivity providing an extraordinary signal reception, this quality of reception is part of the success of this wireless system.
The R3300 receiver has high sensitivity providing an extraordinary signal reception, this quality of reception is part of the success of this wireless system.  There is no hassle to connect it, just Plug and Play.

Receiver Specifications:
16 Channels

GROUP A
CH1: 3320
CH2: 3345
CH3: 3370
CH4: 3395
CH5: 3420
CH6: 3445
CH7: 3470
CH8: 3495

GROUP B
CH1: 3310
CH2: 3330
CH3: 3355
CH4: 3380
CH5: 3405
CH6: 3430
CH7: 3455
CH8: 3480

- Composite video, supports NTSC and PAL standards.
- FM-FM modulation
- 6.5MHz audio sub-carrier (mono).
- DIP switch channel selection.
- RF sensitivity -85dBm (typical).
- Supply current Vcc 240mA (maximum).
- Video input voltage 75-ohm impedance  1Vp-p.
- Audio input voltage 10k ohm impedance  1Vp-p.
- Power-On LED indicator.
- Operating voltage: Vcc, 10.5V (minimum), 12V (typical), 13V (maximum).
- Included stylus for easy channel change
- Dimension 86x 50.8 x 12.7mm.
- Weight Without Antenna: 60g (2oz)
- Power Cable: JST to Barrel 3.4mm x 1.4mm (Center Positive)
- Accessory kit includes antenna and RCA A/V cable.

Slide off the cover of the DIP switches and use its tip as tool for easy channel change.
Also keep the A/B switch on A position.

16 Channels Transmitter Specifications:
Operating band: 3.3 - 3.4 GHz

GROUP A
CH1: 3320
CH2: 3345
CH3: 3370
CH4: 3395
CH5: 3420
CH6: 3445
CH7: 3470
CH8: 3495

GROUP B
CH1: 3310
CH2: 3330
CH3: 3355
CH4: 3380
CH5: 3405
CH6: 3430
CH7: 3455
CH8: 3480

- Audio Subcarrier 6.5MHz
- Operating Voltage Range: 5-16 VDC
- Operating Current: 300mah
- Power Consumption: <2.2W
- Operating Temperature: 0-60c
- Operating Humidity: 20-90%
- Video Output: 75ohm load
- Audio Output: 1k load
- Channel Selection: DIP Switch
- Antenna Connector: SMA
- Phase Lock Loop (PLL) stability for drift-free operation
- Transmission Output Power: 1W (30dBm)
- Frequency Lock Method: Digital Phase Lock Loop
- Weight Without Antenna: 29g (1oz)
- Dimension 47.5 x 69.5 x16mm
 

**This international version can not be shipped to any address in the United States.

 Package includes:

- Plug and play customized version of the T3300 transmitter with built-in microphone.
- High Sensitivity Receiver R3300 3.3 GHz receiver
- Power Plug for receiver is included
- Universal camera leads are included
- Works with any camera PAL or NTSC
- Audio and video output cable with RCA connectors
- 2x whip antennas (Optional and highly recommend upgrading the stock antennas)
-Camera is not included (Optional and recommended for piloting). GoPro cameras are the best to record your video, but we do not recommend using as the main FPV piloting camera, lack of image details due to super wide view lens, and it can to turn off while using it.

 

교환 및 반품 정보

 

상품 사용 후기

 

상품 Q&Amp;A